How do you reset a Norcold refrigerator control board?

Reset Procedure #1

  1. Turn OFF the refrigerator.
  2. Disconnect the following from power board:
  3. Remove the power board cover.
  4. Reconnect a, b, c, & d disconnected in step 2.
  5. Turn ON the refrigerator.
  6. Locate Pin 15 on 16 pin connector (P1).

Is the Norcold gas absorption model refrigerator safe?

Nearly everyone with a Norcold RV refrigerator has heard of the dreaded high temperature sensor recall. Is your refrigerator safe?! Norcold gas absorption model refrigerators (RV models) have cooling units that operate through the heating, evaporating, and condensing of an ammonia solution.

What causes the Norcold safety switch to go off?

As stated above, the overheating of the ammonia solution is the underlying reason behind cooling unit ruptures and blockages. The Norcold safety switch is designed to go off at 800 degrees F and prevent against a potential fire in the RV.

How to troubleshoot a Norcold RV refrigerator?

Keep in mind that the Norcold refrigerator needs full battery power to ignite. If battery power drops below 12 volts, your refrigerator may have a hard time lighting. Also, check to ensure that your refrigerator is grounded to the chassis, and also that the ground wire is connected to the refrigerator. Remove air from propane gas supply lines.

Where is the serial number on a Norcold refrigerator?

There are three places where you can find this number. Look for the serial plate either inside the refrigerator equipment panel, which is accessed via the exterior compartment; inside the refrigerator itself on the inside right corner; or inside the refrigerator’s bottom right panel underneath the produce bin.

Nearly everyone with a Norcold RV refrigerator has heard of the dreaded high temperature sensor recall. Is your refrigerator safe?! Norcold gas absorption model refrigerators (RV models) have cooling units that operate through the heating, evaporating, and condensing of an ammonia solution.

As stated above, the overheating of the ammonia solution is the underlying reason behind cooling unit ruptures and blockages. The Norcold safety switch is designed to go off at 800 degrees F and prevent against a potential fire in the RV.

Keep in mind that the Norcold refrigerator needs full battery power to ignite. If battery power drops below 12 volts, your refrigerator may have a hard time lighting. Also, check to ensure that your refrigerator is grounded to the chassis, and also that the ground wire is connected to the refrigerator. Remove air from propane gas supply lines.

There are three places where you can find this number. Look for the serial plate either inside the refrigerator equipment panel, which is accessed via the exterior compartment; inside the refrigerator itself on the inside right corner; or inside the refrigerator’s bottom right panel underneath the produce bin.