How to put Atwood levelegs system in error mode?
Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated.
How big are the power jacks on Atwood levelegs?
The size is about #22 gauge. These are signal wires only with mini Walden-Molex connectors. The power wires are not a problem. They are about #8 gauge. The connectors to that feed the individual jacks have # 10 or #12 wire and have never been a problem.
What are the flashing lights on my Atwood levelegs?
Periodically, especially if the rig has been sitting for a while, my Atwood Levelegs electric jacks will refuse to retract and will display flashing green and red lights, usually in one corner, indicating which jack is having trouble.
Is the Atwood levelegs grounded on the same bus?
It could be a poor ground, but according to the diagram, all four motors are grounded on the same buss. Check voltage with a digital voltmeter at the control panel while deploying the jacks. If 12+VDC, I would suggest giving Atwood a call at 800-546-8759.
Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated.
When do Atwood levelegs Jacks get cranky?
It seems the jacks only get cranky when they haven’t been used in a while and they are fully extended. If you make blocks like these, I’d recommend using treated lumber, then priming and painting them, otherwise they’ll rot quickly when in contact with the ground.
Periodically, especially if the rig has been sitting for a while, my Atwood Levelegs electric jacks will refuse to retract and will display flashing green and red lights, usually in one corner, indicating which jack is having trouble.
What should I do if my leveling jacks are not working?
Silicones and cleaning agents such as Dawn dish soap can worsen the corrosion and render your system irreparable. So what you should do is spray the system well with WD-40 and then wipe clean.
