What happens if I push the reset button on my modem?
A reset restores your modem to its factory default settings. It will also erase any customized settings you may have changed, including static IP address setup, DNS, personalized password, WiFi settings, routing and DHCP settings.
What are the error codes for the Norcold refrigerator?
Norcold N3104 Series refrigerator error codes Problem Possible Cause Unit senses flame when gas mode is not s – Bad gas valve – Bad power control board and/or LCD dis Burner control module senses incorrect f – Bad burner – Bad power control board and/or LCD dis
What kind of power does a Norcold refrigerator use?
Norcold gas absorption refrigerators operate off of 12V DC power (battery power). The AC plug that you see in the back is only powering your AC Heater/s that will cool the refrigerator when running it on AC or Auto Mode. The 12V DC powers the rear power board, the front control board, and the interior light.
What should I do if my Norcold refrigerator goes into lockout?
The next thing you’ll need to do is jumper a pin terminal on the power board to ground (we recommend something around a 12 gauge jumper wire). The refrigerator must be on and showing the fault code before you jump the pin terminal to ground. Hold the jumper wire to the pin and ground for about 10 seconds or until you hear an audible click.
Where is the jumper wire on a Norcold refrigerator?
Hold the jumper wire to the pin and ground for about 10 seconds or until you hear an audible click. If your power board was made pre 2006, you’ll find a 16 pin plug connector at the bottom of the power board (two rows of 8). On this style board, you’ll need to jump the second pin from the left hand side on the top row to ground.
The next thing you’ll need to do is jumper a pin terminal on the power board to ground (we recommend something around a 12 gauge jumper wire). The refrigerator must be on and showing the fault code before you jump the pin terminal to ground. Hold the jumper wire to the pin and ground for about 10 seconds or until you hear an audible click.
How do I reset Norcold when no co flashes?
In order to reset Norcold fridges when the No Co code flashes one has to take off the cover of the fridge controller. The first time the “no co” fault code appears on the optical control assembly, it can be cleared by the user by turning the refrigerator OFF and then back ON.
Norcold gas absorption refrigerators operate off of 12V DC power (battery power). The AC plug that you see in the back is only powering your AC Heater/s that will cool the refrigerator when running it on AC or Auto Mode. The 12V DC powers the rear power board, the front control board, and the interior light.
