Where is the start switch on a top loader washer?
Some top loaders have a start switch that is a momentary contact type of switch. This switch will be located on the control panel. You can also test this switch for continuity with a multimeter while pushing the button in. Remove power from the washer before testing for continuity. If there is no continuity, replace the start switch and or timer.
Why does my vertical modular washer not start?
A vertical modular top-load washer flashes the Lid Lock light instead of a code when the washer won’t start. This video shows how to troubleshoot flashing lid lock errors on a vertical modular washer.
Why does my top loader washer not spin?
It may fill with water but will not spin if the switch is faulty. Some lid switches on top loaders also control the water inlet valve. In some top load washers, if the lid switch is bad, the washer will not fill with water. The lid switch is under the lid.
What does it mean when your washing machine wont start?
This pin or pusher (when lid is closed) will press the lid switch. If your washer will not start, be sure the switch is being pressed. If the lid switch is being pressed but no power is being supplied to the washers motor, then the switch is most likely bad.
A vertical modular top-load washer flashes the Lid Lock light instead of a code when the washer won’t start. This video shows how to troubleshoot flashing lid lock errors on a vertical modular washer.
How to troubleshoot a washing machine that won’t start?
Troubleshooting a Washing Machine That Won’t Start. 1 Power. If your washing machine won’t start, begin by looking at the power source. First of all, is the washer plugged in? If it is, has it tripped a 2 Lid Switch in a Top Load Washer. 3 Door Interlock in a Front Load Washer. 4 Water Level Switch. 5 Timer Knob.
Where is the motor control board on a front load washer?
The motor control board is a circuit-control board in a front-load washer that’s usually in the bottom of the washer next to the drive motor. It monitors and controls the drive motor speed and direction for the tumble and spin actions during the cycle. If the motor doesn’t run, the motor control board might need to be replaced.
